![]() ![]() NetFlow Alerts - When there is no NetFlow data on the gateway for some time, an email alert will be sent out to the admins.Īllow Suspend - Enable the suspend feature on this gateway. Please be aware that this doesn't work the other way (creating a data link will not create a gateway record in Network settings).Īllow NetFlow - Enable the NetFlow protocol on this router. WAN interface - When selected, it will automatically create a link in the Topology view from that router to the Internet. It is possible to have several gateways, each with a separate configuration. Each gateway has its own configuration with these settings:ĭevice - Provide information about which EdgeRouter in the network serves as the gateway to the Internet. You can either use the button 'Add new gateway' if the list is empty or click on the 'Edit' link for an already created gateway. MediaTek EdgeRouters, like ER-X, are supported with FW 2.0.8+. Any version of firmware is suitable for NetFlow, but other advanced features require FW v2.0.6+ to work properly. NOTE: All EdgeRouters are compatible with new Network functions, as long as they are on the Cavium platform. Detailed info about the Gateway setup can be found below in the next section. Ideally with firmware v2.0.6+ as it offers all available functions while the older FW can only offer NetFlow. For larger networks, we recommend UISP-R-Pro or EdgeRouter Infinity for mid-to-small sized networks, the UISP-Console or EdgeRouter ER-12P. UISP Console, UISP Router) or EdgeRouter devices can be set up as UISP Gateways. In the Gateways subsection, admins can define and edit gateways that serve as the entry point from the Internet into the network. ![]() Gateways - Gateways are critical for the correct behavior of advanced UISP Network features. Traffic Shaping - Here it is possible to define if the traffic shaping should occur only on the gateway or on CPE devices as well. NetFlow can be monitored from any NetFlow compatible router, but it works best when enabled on a Ubiquiti device that has been added to the Gateways subsection. Netflow - This section displays the general status of the NetFlow traffic measurement as well as a list of any router IP addresses defined in the Addresses subsection that have presented recent data flow. Basically, this section allows admins to separate their internal network from customer areas. When left empty all private subnets will be used. Those subnets will be then monitored by UISP and NetFlow, as well as used for Traffic shaping and Suspend features. The network section has several subsections:Īddresses - In this section, all network subnets can be defined. In order to start using advanced network features navigate to Settings > Network. ![]() In order to make those features work it is critical to have a well-defined topology view. Instead of specific devices, those features are focused on the whole network and allow UISP to understand its complexity. UISP features the option to configure network management features. Prominently: Traffic shaping, Suspend, and NetFlow. This article introduces new network features for UISP. ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |